How to Best Attend on the Sand Maker

How to Best Attend on the Sand Maker

Zhengzhou, China (prHWY.com) May 21, 2012 - Hongxing Sand Maker is a newly researched equipment, with international advanced level. Technology and modern processing equipment make it a leading role in this industry. It is widely used for artificial sand, in metal and non-metal ores, cement, refractory material, bauxite, silicon carbide, glass material, building material.

This powder grinding equipment has many advantages compared with other series:

1. Advanced double-pump oil lubrication system guarantee shaft bearing lower temperature increase, longer life time, more reliable operation.

2. Main shaft is equipped with imported precision rolling bearing. It makes main shaft work stable, lengthen maintenance cycle, increase productivity.

3. Hydraulic lifting mechanism of upper cover can move away the cover easily, which saves man power during maintenance.

4. Over-vibration device is equipped. There will be alarm when vibration surpasses a stipulated figure. It will stop the machine, in order to protect it.

5. Special dust-proof design for main shaft bearing fully avoid dust entering bearing lubrication part, which make sure the machine work normally.

6. Special feed opening structure make it possible that center feeding and ring feeding comes together, in order to meet requriement of different stones. In addition, this equipment can not only crush stone, but also iron.

7. Shape of material-throughing device is better designed, which improve the utilization ratio.

For this reason, the repair and maintenance of the machine iteself is extremely important in order to extend its service life.

1. Check the whirlpool cavity's observation door whether it is closed tightly, in case the materials is fired from the observation door, to cause danger. Check the rotation direction of the impeller .The impeller should rotate in the counter clockwise, or the electro motor's wiring should be adjusted.dryer machine:http://www.hx-crusher.com/dryer_machine.html
ore beneficiation:http://www.hxjq-crusher.com/63.html

2. The start sequence of the crushing breaker and convey equipment. Discharge â†'breakerâ†'feed Breaker muse be started up under no loading condition, the materials should be fed after the breaker is in good order.

3. The sequence of shut down and start up is opposite. The feed size should be according to the requirement of every kind of machine strictly, materials over the requirements must be forbidden otherwise imbalance is produced and the impeller is wired heavily, even the tunnel of impeller and middle of feed tube will be jammed, as a result the machine can't work well. Feeding should be continuous and even, The huge shake and abnormal noise shouldn't exist in the process of the operation, or the Sand Making machine should be shut down and checked.

4. The style of lubrication is dry-oil lubrication; the mobile automobile-used lubricating grease and 3 # spodumene grease should lubricate the machine, proper grease should be added to the breaker per 100 hours.

5. Turn off the Sand Making machine regularly and open then observation door to watch the information of the machine's wear, including the middle tube's ,cone cover's, impeller's, lower tunnel layer's, throwing materials part's, if there is heavy wear ,they should be replaced or repaired in time, when changing the cast hammer head ,pay attention then weigh is the same as the replaced one .The wear impeller should be replaced or repaired by factory in time ,Note :without the factory's agreement, customers are not allowed to make the Impeller themselves, opening the observation door is forbidden in the process of machine 's operation, in case the danger happened, or the customers should take the responsibility.

###

Tag Words: None

Categories: Business

Link To This Press Release:

URL HTML Code