Installing a split air conditioner Orlando
The split air conditioning unit is removed from the packaging. A hole is drilled in the wall for the passage of wiring from the indoor unit and the outdoor unit. The hole should be of optimum size. It should be large enough for the wiring and connect

The split air conditioning unit is removed from the packaging. A hole is drilled in the wall for the passage of wiring from the indoor unit and the outdoor unit. The hole should be of optimum size. It should be large enough for the wiring and connections to pass but not too large to contribute to energy loss. Pieces of fiberglass insulation are used to seal the area around the hole. The outdoor unit is attached to the wall to any mounts that accompanied the packaging. The indoor unit is secured to the wall and placed in an area that permits the maximum amount of airflow.
After the installation of the indoor unit is over, the wires and other connectors are taken that have been fed to the outside through the hole and are connected to the back of the outdoor unit. The outdoor unit is then placed and secured. Once secured, the unit is plugged to the nearby electrical outlet and the system is run in order to test the connections. Adjustments, if necessary are made to run the air conditioner properly.
Call your Facility Pro Tech technicians for Orlando ac service to get what you desire.
###
Tag Words:
air conditioner orlando
Categories: Business
Press Release Contact
Facility Pro Tech - Office Location
4065 LB McLeod Rd., Suite G-1
Orlando, FL 32811
Phone: 407-608-5370
Fax: 407-841-0060
Facility Pro Tech - Office Location
4065 LB McLeod Rd., Suite G-1
Orlando, FL 32811
Phone: 407-608-5370
Fax: 407-841-0060